Core 2.0 Replacement Glass
This is a replacement glass for the Core 2.0 E-rig. Why limit yourself to dabbing using a traditional dab rig when there’s a more convenient and efficient device? Core 2.0 E-Rig is the perfect dabbing device you deserve.
The Core 2.0 E-Rig is made of isolated aluminum and has a glass vapor pathway. Its rebuildable atomizer removes the need to replace the whole housing – you just need to replace the heater. It has a one-button functionality for easy usage – you need a single button to operate the device. You can use this E-Rig with many concentrates within a few clicks.
It also features Vortex Airflow with an aluminum spinner carb cap with a tether. With this E-rig, you get a ceramic vaping surface, stainless steel carb cap tube, and a borosilicate glass bubbler.
Maintenance is easy and hassle-free – its 3150mah Li-Ion battery pack only requires an hour and 45 minutes to charge fully. This allows you to enjoy long sessions without interruption. Take care not to overcharge or over-discharge the device to prevent overheating and short-circuiting. Core 2.0 E-Rig is easy to clean; all you need is water and Q-tips.
The FDA-approved Core 2.0 E-Rig is a durable device designed to be your long-lasting cannabis companion.
FAQ
How do I set up Core 2.0?
Charge your base using the wall plug and cable provided in the kit. Remove the bubbler from the base and fill it with water. Ensure no excess liquid or flooded water is in the bottom compartment. If such a case happens, turn the bubbler upside down and blow it into the air hole at the bottom to clear the area.
Now place the bubbler into the base. Ensure that the hole in the bubbler base aligns with the vapor pathway. Gently push the bubbler straight down into place.
Check and tighten the small screws in the atomizer. After that, screw the atomizer into the base. Place the stainless steel carb cap tube on the base. The wider angled side should sit at the top. This leaves the carp cab on the tether so you can load the material into the heater. Choose your preferred heat setting.
What dabbing methods can I use with Core 2.0?
You can use either the Cold Start or Hot Start methods. Cold Starts are best for getting the most flavor and material preservation from the vapor. Using it this way will cause the session temperatures to be slightly lower since the air passing around the heater will decrease the heating speed.
On the other hand, Hot Start allows the heater to reach the full temperature for any given setting. This method is best for getting the maximum cloud production and effects as quickly as possible.
How do I use Core 2.0?
Load the concentrate into the heater and then press the button twice to activate session mode. When your concentrate starts to bubble, begin using gently with the carb cap off.
When the Core 2.0 base vibrates, place the carb cap back on and continue your use as you usually would. Press the button once to cancel the session when the vapor becomes harsh or stops producing.
If you still have some concentrates left inside after the session, hit the fire button twice. After that, you can start using the device right away. There's no need to wait for it to vibrate since your heater is already close to an adequate temperature. The second session will always run a little hotter than the first if you start it straight after.